Metabolic

Amlexanox 100mg Vial Dosage Protocol

Reconstitution and dosing for a 100mg vial of Amlexanox — concentration by BAC-water volume, the units to draw on a U-100 syringe, and the cited dosing chart.

All Amlexanox protocols

Other vial sizes50 mg 100 mg

Routesubcutaneous

Amlexanox — Dosage chart

Every row cited

Goal	Dose	Frequency	Duration	Evidence	Source
Renal fibrosis / CKD (preclinical, renoprotection via TBK1 inhibition)	3–30 mg	per trial	per trial	Preclinical	PMID 41110750
Painful diabetic neuropathy (preclinical, TBK1 inhibition)	3–30 mg	per trial	per trial	Preclinical	PMID 39030571

For research and educational use only. Not medical advice.

How to Reconstitute Amlexanox

U-100

A common approach: reconstitute an example 100 mg vial of Amlexanox with bacteriostatic water. The table shows the resulting concentration and the volume to draw for a 3–30 mg dose at three common water volumes.

BAC water	Concentration	Volume / dose	Units (U-100)
1 mL	100 mg/mL	0.03–0.3 mL	3–30
2 mL	50 mg/mL	0.06–0.6 mL	6–60
3 mL	33.33 mg/mL	0.09–0.9 mL	9–90

Units shown are for a U-100 (1 mL = 100-unit) insulin syringe. Always verify your own math before drawing.

Supplies Needed

A typical reconstitution-and-injection kit includes:

Lyophilized peptide vial(s) — enough for the full protocol length
Bacteriostatic water for reconstitution
U-100 insulin syringes (one per injection)
Alcohol prep swabs
A sharps container for safe disposal

Storage, Handling & Injection

Storage & handling

Lyophilized (freeze-dried) peptide is typically kept refrigerated and protected from light; once reconstituted with bacteriostatic water it is generally refrigerated at 2–8 °C and used within a few weeks. Follow aseptic technique to avoid contamination, per CDC injection-safety guidance.

Injection technique

Subcutaneous injections are usually given into the fat of the abdomen or thigh: clean the site with an alcohol swab, pinch the skin, insert at the recommended angle, and rotate sites to protect the tissue. See MedlinePlus for a step-by-step subcutaneous-injection guide.

General aseptic-technique and injection references for educational use — they are not specific to any research compound.

Amlexanox FAQ

What is the typical Amlexanox dosage?

In research, Amlexanox has been studied at 3–30 mg per trial for Renal fibrosis / CKD (preclinical, renoprotection via TBK1 inhibition) (per trial). See the chart above for every studied protocol, each cited.

How do you reconstitute Amlexanox?

Mix the lyophilized Amlexanox with bacteriostatic water, then use the concentration to find your draw volume. The calculator on this page does the math for you.

Is Amlexanox dosing backed by research?

Yes — every dose on this chart maps to a peer-reviewed source. Figures we cannot anchor to a study are left out. Amlexanox is a research compound for laboratory use only.